Forum

Spiral fine gold recovery wheels

Posted by Harry Liddell on November 11, 2012 at 1:32pm in General Discussions
Has anyone had any luck or suggestions about fine recovery wheels. I have been thinking about the Desert Fox unit but am not sure if it is the right move. It is very hard to figure out which unit would be best to use. I screen all my material down to 30 or 50 mesh but I know I'm missing out on the fine gold. If anyone has any comments I would love to hear them.

You need to be a member of Goldprospectorsspace to add comments!

Join Goldprospectorsspace

Email me when people reply –
Follow

Replies

  • ken brant November 11, 2012 at 6:38pm

    keep runing it back  over until you quit getting color

  • durant November 11, 2012 at 2:45pm

    Yes I am happy with it, and I do have the standerd one. This summer was the first time I tried gold cube and if I had the money I would buy one. the cube you take it down to 1/4 in" and run it throw the cube than I ran it throw window screen than throw the panner.

    • Harry Liddell > durant November 11, 2012 at 3:01pm

      Thanks, You have been very helpful. I have a gold cube but I wanted to get every bit of gold I could. I think with the spiral unit I can.

  • KEN AKA BIG FOOT MOUNTAIN MAN ID November 11, 2012 at 2:31pm

    i have 2 of the desert foxd they wok great asd lomg as you classify your materal and run the different sizes 

     

  • durant November 11, 2012 at 2:20pm

    I have a Desert Fox and when you get it set just right you can get out gold at 100 mesh, but you need to use jet dry. that was con off of a gold cube.

    • Harry Liddell > durant November 11, 2012 at 2:28pm

      Thanks,

       So you ran all yourmaterial thru the gold cube first. Are you happy with the desert fox? Did you buy the standard model?

This reply was deleted.