Advice needed, should I run my blaksands and -100 cons wet or dry when I put them on a water table?
You need to be a member of Goldprospectorsspace to add comments!
This reply was deleted.
Advice needed, should I run my blaksands and -100 cons wet or dry when I put them on a water table?
You need to be a member of Goldprospectorsspace to add comments!
Replies
Hey John... add a bit of jet dri to the water for running the table.... Prewet the material as well, place a few drops of jet Dri to that WETTING Water... if DRI Material is added to the waterflow...it will FLOAT out and off the table by Water tension, and possible oils, still on the Gold From the soils..Wetting allows the Gold/Bs to settle Quickly, Near the Top of the table... and the BlackSands flows slowly off ...the Gold Heavier than the Same Size Particle of Blacksand will Stay near one spot, Bs moves down the table.... Proper screening for particle size is Required for best Results.. No rippling of the water flow from to much water Current as it goes down the table... Slow and Steady! Almost Flat! ,, GET R DONE
thanks I am new to all this just been me and my pan.